Need dimension from the hole to the bottom

Return to the 26-197 product page.
This discussion is in regards to the SWISCO product:
product thumbnail of 26-19726-197 : Upper Sash Tilt Bar, 2 13/16"
Metal tilt bar with wings. This pivot corner with tee bar has Patent Number 4926524.
A landlord from Westchester NY says:
date: 05-10-09
What is the dimension of the screw hole from the bottom of the unit.
Paul from SWISCO.com responded:
date: 05-11-09
Take a look at the image in this post of the view of the bottom of this window tilt bar. I believe this is the dimension you have asked for.
Additional image of the 26-197 - shows the base of the window tilt latch
A landlord from New YOrk says:
date: 05-11-09
That isn't the hole I am concerned about. The tilt bar is installed in the frame with the tilt pin out. The screw to hold the frame together goes through the side hole in the tilt bar and tightres to the plastic in the upper frame. I am trying to make sure that the hole the screw passes through in your bar matches my old one. The hole I refer to is to the left of the picture and runs through the unit left to right.
Donna from SWISCO.com responded:
date: 05-15-09
It measures 3/4" from the side hole center to the base.
Add your own message


(receive an email when responses to your question are made)
Your Basket Is Empty
Swisco Window & Door Weatherstripping ~ Prevent unwanted drafts and reduce heating bills with SWISCO replacement weatherstripping.
HACKER SAFE certified sites prevent over 99.9% of hacker crime.

Hardware: Closet | Commercial | Door & Window | Drawer & Cabinet | Lavatory | Tools

Policies: Conditions of Use | Privacy | Shipping | Return/Exchange

© 2009 SWISCO.com "The Replacement Hardware Authority" | About Us | Contact Us