SWISCO - The Replacement Hardware Authority

The 26-234 turned out to be the wrong size for my window

A contractor from princeton nj says:
i got your 26-234 s and the clips are to short they need to be 3/8" rather then the 1/4 that the 26-2345 measure "deep"

all the other sizes are fine

the with of the pins is 3/16"
with of clips at base is 1/4"
over all size is 7/8" x 2 "
User submitted a photo of a tilt latch.
Profile picture of Paul
Paul from SWISCO responded:
I'm sorry to hear you're having trouble, but I haven't been able to find a thumb lever like this in the size you need. To be honest, internal tilt latches can be tricky to replace even in the best of times, so you may want to consider replacing your inside tilt latch with a surface mounted tilt latch. This could be a much easier solution in the long run. Watch the video below to see how.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)