SWISCO - The Replacement Hardware Authority

40-196 backset

A quick learner from Mass says:
This looks like what I need to replace some Jados, but
I need a 1 inch backset, what is the backset on this unit?
And a follow up, are dummy knobs/escutcheons available?
Profile picture of Dave
Dave from SWISCO responded:
The backset from the edge of the face plate to the center of the spindle is 1". Is that the measurement you were referring to? Also, do the rest of the measurements match up?

I'm afraid we do not have a dummy version of this handle available.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)