SWISCO - The Replacement Hardware Authority

Drawer track back plate

A handy person from Redondo Beach, CA says:
On the back plate there is a capital letter "R" and the number "60.1890" OR "50.1890" (very small and hard to read).

Length (height in the photo) is just under 2.5"

It fits 1" tall x 3/8" wide drawer track.

I think this part:

http://www.swisco.com/drawer-track-bracket/pd/Replacement-Drawer-Sockets/32-089

should work with redrilling the screws but wanted to see if there was anything closer to the original.

Thanks!
A handy person from Redondo Beach, CA says:
trying to upload the image again - failed the first time.
User submitted a photo of drawer hardware.
Profile picture of Dave
Dave from SWISCO responded:
I agree, the 32-089 looks pretty close. Just make sure all the dimensions we show line up to your own measurements before you make your decision.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)