SWISCO - The Replacement Hardware Authority

Extra dimensions for 39-076?

A quick learner says:
are the screw holes on the handle side 2" apart
on part#39-076 and hex internal drives the same size
apporx. 5/16 or so
Profile picture of Dave
Dave from SWISCO responded:
I pulled one of our 39-074 operators from our stock to check the hole centers on the back of the operator. They have 8-32 threaded holes for a machine screw and are 2" apart, on center. The front spline hole for the operator shaft is 1/4", and the side holes are 3/8" hex. I hope these measurements help.
A quick learner from vacherie, louisiana says:
thanks that's just what I'am looking for will order a soon as I can

Owen K
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)