SWISCO - The Replacement Hardware Authority

Legacy lock spindle in the wrong spot

A quick learner from California says:
I just bought the Legacy Keyed handle set, but the lock spindle doesn't match my hardware. There are two hole pre-cuts showing on the inside of the handle, marked A and B.
The handle I bought uses the below-center option, but I need the center option. Can I get that?
Profile picture of Tom
Tom from SWISCO responded:
I'm afraid our Legacy handle sets only have that offset orientation. You may want to consider our 82-069 handle set, which has an adjustable thumb lever that can work at any position (top, center, bottom). It does not come keyed, but you can use our 82-310 cylinder with it.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)