SWISCO - The Replacement Hardware Authority

Lock catch for my door lock

A quick learner from Denver, CO says:
I have a similar handle to the one in this discussion, also marked 1060-1943. The handle and lock are fine, but I don't have the lock catch. There are holes where it used to be. Measurements are:

Height: 1 1/2"
Width: 1"

Attached a picture.

Do you have a part that is similar to this thread pattern?

Thanks, Sheri
User submitted photo of their patio door keeper.
Profile picture of Dave
Dave from SWISCO responded:
Hey, Sheri. It's difficult to find a replacement without the original on hand for comparison, but look at our 89-024, which is 1" wide. Could that work?
A quick learner says:
I saw this one, but don't think it would work. The holes are 1" apart, and the part you provided is 1" total, so the holes would be narrower. There was another part I think might work, i think it was 89-029. What do you think of that one?
A professional from CA says:
Personally, I would recommend the 89-029. The other one tends to fit too tightly on this type of lock cartridge and stick in the locked position.
Profile picture of Paul
Paul from SWISCO responded:
I agree, the 89-029 appears to be the superior choice.
A quick learner says:
Ok, I ordered 89-029, let's see what happens!

Thank you for your help.

Sheri
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)