SWISCO - The Replacement Hardware Authority

Need dimension from the hole to the bottom

A landlord from Westchester NY says:
What is the dimension of the screw hole from the bottom of the 26-197 unit?
Profile picture of Paul Sr.
Paul Sr. from SWISCO responded:
Take a look at the image in this post of the view of the bottom of this window tilt bar. I believe this is the dimension you have asked for.
Additional image of the 26-197 - shows the base of the window tilt latch
A landlord from New YOrk says:
That isn't the hole I am concerned about. The tilt bar is installed in the frame with the tilt pin out. The screw to hold the frame together goes through the side hole in the tilt bar and tightres to the plastic in the upper frame. I am trying to make sure that the hole the screw passes through in your bar matches my old one. The hole I refer to is to the left of the picture and runs through the unit left to right.
Profile picture of Donna
Donna from SWISCO responded:
It measures 3/4" from the side hole center to the base.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)