SWISCO - The Replacement Hardware Authority

Need wider inset part for bug flap

A quick learner from Sarasota, FL says:
I need two bug flaps that look like your 59-054 except the width is 1 1/4 and not 1 9/16. No problem, they can be cut down. The 3/8 depth is ok although mine are 1/4. The critical measurement is 1/2 in. instead of 11/32. I bought some flaps locally and they just fall out. The sliding screen is 1983 era. Any suggestions?
Profile picture of Tom
Tom from SWISCO responded:
Thanks for posting! Have you seen our 59-057 bug flap? You still might have to cut down the height, but the push-in portion is closer to your measurements than the 59-054. Would this work for you?
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)