SWISCO - The Replacement Hardware Authority

PHILIPS STATON SERIES LOCK

A contractor from GRAND JUNCTION says:
WE HAVE AN ALMOND PHILIPS STATON SERIES (NOV 2007) THAT NEEDS A NEW LOCK. WHAT PART # COULD WE USE FOR THE LOCK? THE SCREWS ARE APPROX 4" APART. CAN WE ORDER JUST ONE PART FROM YOU?
Profile picture of Paul
Paul from SWISCO responded:
I'm afraid I'm not familiar with that Series. Could I see a few pictures of the hardware in question? Thanks!
A contractor from GRAND JUNCTION says:
I don't have a picture but do have this crude drawing.
User submitted a diagram of a door handle.
Profile picture of Tom
Tom from SWISCO responded:
Thank you! It could be our 82-069. Check it out and see what you think. I would double check the measurement you had for your screw hole spacing. I think it might be 3-15/16", not 4". Make sure to measure from the center of each hole, not the edges.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)