SWISCO - The Replacement Hardware Authority

Instructions for Pella Sliding Trolleys

A handy person from Wyoming says:
I have a 72" wide Pella sliding glass door circa 1992 with a 35" wide screen that automatically closes using a 26" spring assy with rollers on either end and located in the top of the door frame. The screen door mounts on this spring/roller assy with 2 long attaching screws close to either end that also adjust (level) the door in the frame.
While reinstalling the screen after painting I broke one of the two plastic mounting/roller brackets located on either end of the assembly.
So, now I have the following questions:
~ Can this spring/roller assembly be replaced?
~ If so, do you sell it or know where can I purchase it?
~ If so, how do I remove the assy from the door frame?
~ If not, can I do anything to re-mount the screen in the frame?
~ Any ideas short of replacing the entire Pella sliding door would be much appreciated!
Profile picture of Mike
Mike from SWISCO responded:
Good Morning,

Yes, the screen door spring can be replaced. See parts 80-053, 80-054, and 80-055. You will need to measure your existing spring trolley to figure out which size you need.

Here are guides provided by Pella for their automatic screen door.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)