SWISCO - The Replacement Hardware Authority

Rear plasstic bearing for Century furniture drawer

A home owner from Clemmons, NC says:
I tried a bracket that looked close, but the bearing that runs in the slide was slightly too small. Any suggestions? Outside dimensions are approx. 1 3/4" H X 3" W outside, 5/16" H X ! 3/16" W bearing. Thx
User submitted photos of a drawer guide.
Profile picture of Dave
Dave from SWISCO responded:
Take a look at our 32-036 and 32-118 and see if either would be a good match.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)