SWISCO - The Replacement Hardware Authority

Repacement Part for "Hdwe Designers NYLSlide NO.250"

A quick learner from Westwood, NJ 07675 says:
I am lookong for 3 replacement rear draw guards for a Hdwe designers NYLSlide NO. 250. Attached picture #1 shows the actual part with dimensions. Attached picture #2 shows part installed on rear of draw, screwed into the draw using the top left and right screwhole. Bottom goes over and around the slide railunder the draw.

P.S.Thickness is 1/4" at bottom and 1/8' by the screwholes at the top

Thanks for your assistance
Best regards
User submitted photos of drawer hardware.
Profile picture of Paul
Paul from SWISCO responded:
Hi, Mike. See our 32-035 drawer guide. I think this could be what you want, but check it out just in case.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)