SWISCO - The Replacement Hardware Authority

Replacement roller for an Alside patio glass door

A home owner from Centennial, Colorado says:
I am looking at your picture of part # 81-030. I can't tell if this part has the screw mounting hole on the top similar to the mounting holes located on Part #81-095 and part #81-138.

I'm trying to replace the Tandem rollers on a 6'0 x 6'8" patio door manufactured by "Alside" installed in 9/96.

The current part has two (2) 1 1/4" rollers

Thank You.
Jerry B.
Profile picture of Dave
Dave from SWISCO responded:
The hole on top of the body of the 81-030 sliding glass door roller assembly is not threaded. Here is a close up view of the hole.
Close up of the top hole on the body of the 81-030 sliding glass door roller.
If you can, upload a couple pictures of your current roller and I will see if I can identify a replacement roller for you.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)