SWISCO - The Replacement Hardware Authority

Replacement sliding door handles, mortise lock and keeper

A quick learner from MA says:

The handle to my sliding glass door broke several years ago and I wasn't very smart about replacing it! I threw away the parts thinking they would be easily found and replaced. I have been looking for replacements since...to no avail!!! Consequently, not have photos of the parts, but have enclosed pictures of the door without the hardware. The top and bottom handle mounting holes are 3 7/8 " center to center. The opening for the face plate of the mortise lock is 6" tip to tip and 7/8" wide. The opening for the actual lock is 4" tip to tip and is 1/2 wide. The opening for the keeper is 2" tip to tip and seems to be slightly wider than 1/2 in. It is difficult to accurately measure due to the door's casing.

If you could provide me some suggestions for products to fit this door...I would greatly appreciate it!

Thank you so much!
User submitted photos of patio door hardware.
Profile picture of Dave
Dave from SWISCO responded:
It's hard to say what you have without seeing the original hardware, but start out by looking at our 82-035 and see how well this meets the space where the old handle was installed. As for the mortise, you could consider our 82-229, 82-244, 82-11, or 82-214. Carefully examine these parts and see if any look familiar.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)