SWISCO - The Replacement Hardware Authority

Roller assembly mirrored closet door

A home owner from USA says:
Hello,

I need some roller assemblies for two sliding, mirrored closet doors.

Roller is 1 1/2" in diameter and is marked KILIAN TORONTO, CAN 2 SYRACUSE N.Y.

Casing is approximately 2 1/2″
User submitted photos of a closet door roller.
Profile picture of Dave
Dave from SWISCO responded:
Thanks for contacting us. Can you give me the dimensions of the housing? That will also help. I would specifically like to know the width, height, and length of the housing, as well as any other dimension you think would be relevant. In the meantime, check out our 81-027 and see if this could work. Note that the wheel is only 1-1/4", but you may be able to adjust its height to compensate.
A quick learner from Denver, Colorado says:
Roller is 1 1/2" in diameter and is marked KILIAN TORONTO, CAN 2 SYRACUSE N.Y.

Casing is approximately 2 1/2" x 1 3/8" x 5/8" (almost 3/4" in places) and is marked DEL MAR ENG. PAT. PEND.

Door is marked GARDNER MIRROR FEB. 27, 1979
Profile picture of Dave
Dave from SWISCO responded:
I can't seem to find your exact closet door roller. However, take a look at our 23-176. It is 5/8" when you measure the side flares while complete housing measures 1-1/4", and it has a 1-1/2" nylon wheel. It is held in place with the hole in the end bracket. Looking at your photo it appears the door has a spline groove on the bottom rail where a screw goes to hold the frame together. What do you think?
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)