SWISCO - The Replacement Hardware Authority

Strato-fold door hardware

A quick learner from USA says:
I have an old Strato-fold door. It is a single bi-fold door measuring 36 x 96. Serial # 16808. I need the full set up of hanging hardware. Some of the parts are missing so it's hard to determine exactly what I need from your site.

In looking at the schematic on the back side of the door, I need:

2 (?) - BM 1 Track block(s)
1 (?) - BM 4 Pivot pin(s)
??? - BM 5 Spring(s)
??? - BM 6 Retainer ring(s)
??? - BM 7 Retainer(s)
??? - BM 8 Retainer screw(s)
??? - BM 9 Upper and Lower Guide pin(s)
??? - BM10 Slide bushings
??? - BM 12 Adjuster pins
??? - BM 13 Retainer nut(s)
??? - BM 14 Track screw(s)
??? - BM 15 5/16 x 18 rnd head screw(s)
??? - BM 16 5/16 square nut(s)
??? - BM 17 Grommet(s)
??? - BM 18 Fastner(s)
Profile picture of Paul
Paul from SWISCO responded:
There is an easier way to do this. I think you may need two 21-401 tracks, one 21-001 bottom threaded adjusting bi-fold pin, and three 21-007 bi-fold guide pins. Look at this hardware and tell me if you think they will work for you.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)