SWISCO - The Replacement Hardware Authority

Super Seal Parts

A contractor from York PA says:
Need at least 3 pr. of window latches. Not the locks but the plastic latches that snap into the jamb.
I was told i need 26-121 R and 26-120 L
Can you help me out?
Thanks!
Steve
User submitted picture of surface mounted tilt latch.
Profile picture of Mike
Mike from SWISCO responded:
Thank you for sending us your pictures, Steve.

Can you give us the distance between the screw hole centers?
A contractor from York PA says:
Mike,
I am finally getting back to you with the measurement you wanted between the screw hole centers. it is 2"
Thanks!
Steve
Profile picture of Mike
Mike from SWISCO responded:
Thanks for getting back to us, Steve. To be honest, based on the style of the latch alone, I think it may look closer to our 26-228 & 26-229 tilt latches. Please confirm your screw hole measurements to see if they may in fact be 2-1/8". Also make sure that you're measuring from the center of each installation hole, not the edges of the holes. Let me know what you think!
A contractor from York PA says:
Yes, they are 2" centers. I did measure them.
Thanks!
Profile picture of Mike
Mike from SWISCO responded:
In that case, I think the closest options we have are our 26-337 top tilt latch pair, and our 26-344 top tilt latch pair. Do you think these may work better?
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)