SWISCO - The Replacement Hardware Authority

Super Seal Series 800SGD mfg. date 2001

A home owner from Baldwinsville, NY 13027 says:
I am looking for the keeper for the latch in the sliding screen door. The keeper is screwed into the door jam with 2 screws. It is approximately 3/4" in height and 1/2" wide. It appears to be made of die cast aluminum and an L shaped finger approximately 1/4" wide projects out from it.

this is on a Super Seal sliding glass/screen door series 800SGD made in 2001

Profile picture of Tom
Tom from SWISCO responded:
Can I see a few pictures of the keeper in question? That will help us find a good replacement.
A home owner from Baldwinsville NY says:
I am sorry Tom, the L shaped finger protrusion broke off and I am afraid the keeper was thrown out.
Profile picture of Tom
Tom from SWISCO responded:
Ah, I see. That will make things a little harder. Could it be something like our 83-034? Look this over and see what you think.

If not, please show us the spot where the keeper installed and the lock that would engage it. Please also tell me the hole spacing, measured from the center of each hole. Thanks!
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)