SWISCO - The Replacement Hardware Authority

bottom pivot pin - not corner

A quick learner from rI says:
Have unknown mfg steel doors with mirrors. parts are not the same on all doors.

Need to replace a bottom pin with spring; goes into slide on bottom track. Present pin has no hole for carter pin, but all others do.

Pin is 4 1/4" long and 1/4" diameter. wish to replace with one with a hole for carter pin; will also need spring and carter pin and nylon sleeves.

Will the 5 1/4' pin by OK??
Profile picture of Paul
Paul from SWISCO responded:
Are you talking about our 21-058 pin guide? If so, the longer pin shouldn't be a problem.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)