SWISCO - The Replacement Hardware Authority

crank extension to get past window shutters

A home owner from Homer Glen, Illinois says:
Hello, I had window shutters put in and I need an extention for my crank to come out past the shutters to turn. Looking at your 4" crank are they pretty standard for all casement window crankers??
Profile picture of Tom
Tom from SWISCO responded:
No, it really depends on what operator you have. What is the size of the spline for your existing handle? Basically, that's the handle's hole.
A home owner from Homer Glen says:
Thank you for writing back but I honestly have no clue what that would be. I am going to guess here that I think I measured this right and say 11 mm in diameter??? Does that sound right?? They are Norco windows. Old Norco windows. Without all this conversation, I was just gonna order the 39-157 extension.
Thank you so much!!
Profile picture of Tom
Tom from SWISCO responded:
I'm not sure what you measured, so I can't say. The 39-157 has and accepts an 11/32" spline. For example, it would work with our 39-114L, which also has an 11/32" spline. Check out the image below to see what you would measure for the 39-114L. What is this for your own handle, in inches?
Alternate view of the gear hole
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)