I sent a prior request . This a follow up.
I need a pivot that is broken . It's channel shape w 2 holes and two slots and is 3" long. I sent 2 photos one of a good piece and one of broken one. I'll replace both since one is warped.
The sash weighs 9 lbs.I also need a balancer coil that broke. It says 5.33" and a word pending. I probably need a new shoe also and I'm not sure what the white piece is above it w a rubber piece. I probably need another one of those. One photo is broken balancer and one photo is good balancer and one is broken one out of window.Please help!
Jasmine from SWISCO responded:
September 25, 2023
Thanks for reaching out! Your coil balance pivot shoe looks like our 15-111. Carefully compare the measurements to your existing pivot shoe to confirm that this is the right fit. Alternate image for 15-111
The compatible coil spring is the Series 160 Coil. Specifically, your coil balance spring should be our S160-5 since it is marked with a 5. Your pivot bar looks like it could be our 26-063. Carefully review the dimensions for the hole placement to determine if this might be a fit. The length should not affect the function of the part, so those are the most important measurements to confirm. Alternate image for 26-063
You may also need the bumper, part 15-148. Again, look over the dimensions to confirm that this might be a fit. Dimensions for 15-148
|
Jasmine from SWISCO responded:
September 26, 2023
It looks like your coil balance assembly uses both the cover and the bumper. The 15-150S would be the correct cover for your balances. The hook on the end of the coil balance is what connects them together. The support and the bumper give the assembly added support. |