I have a Pella sliding glass patio door with screen door (circa 2005- 2010 install).
The screen door needs repair.
1) worn/chipped rollers (4)
2) new screen & rubber cord
3) following vertical rubber bug, wind, moisture flexible sealer strip
Dimensions:
Screen door: 77 1/2" X 35"
Screen foot print: 73 3/4" X 31 1/2"
Following seal: 1 1/8" wide, insert 1/4" deep
(channel is ~ 1/4")
Photos included with ruler shown
All screws I have seem re-usable.
The aluminum frame seems solid all the way around including corners(but if a
reinforcement is available, want that also)
Photos attached.
Parts available? Cost for those that are.
Kelly
Casey from SWISCO responded:
July 5, 2023
Hello, I would recommend starting by comparing the specifications of the 84-008 screen door roller to yours. We may be able to replace some of your seals as well but we would need to see clear end profile photos of each one uninstalled, along with written-out dimensions, to compare to our inventory. Thank you! Alternate image for 84-008
|
Additional photos :
See attached for -
(1) end view of "following" rubber flat seal.
1 1/8" wide x ~ 1/4" to 3/16" thick
throughout 77 1/2 " length ?..
with a ~ 1/4" square integrated segment
on underside that fits into the metal
channel for stability/attachment. The entire
seal slips onto narrow aluminum edge
lips that run the entire length of the door
frame channel (on "following" side of the
screen door).
(2) view of "following" strip seal showing it
mounted on the screen door frame.
The integrated 1/4" square rubber segment
fits into the metal channel as it is mounted
(slid) onto the door frame "following"
along the entire length (77 1/2 " length).
I will try and call tomorrow afternoon to discuss
this to answer any questions and hopefully complete an order for all repair parts I need that you may have.
Thank you for your help.
Kelly
Casey from SWISCO responded:
July 6, 2023
Unfortunately, it doesn't look like any additional photos came through with your response. If you could resend them, we can go from there. Also, please note that our parts team does not have direct phone lines, so all questions would need to be addressed in this thread. |