SWISCO - The Replacement Hardware Authority

drawer back bracket/socket

A quick learner from texas says:
no markings of any kind on the product
User submitted photos of drawer hardware.
Profile picture of Tom
Tom from SWISCO responded:
Thanks for posting. Can you tell me the height and width of your track? That will help us find the best possible replacement socket. Keep in mind that I do not need the track length, just the width and height. Thank you!
A quick learner says:
height of track is 15/16"
width 1/4"

bracket itself measures 4 15/16" in length
the slot is 7/8" at it's deepest
the slot itself measures 1 1/16" tall x 7/16" wide
Profile picture of Paul
Paul from SWISCO responded:
Thank you! Looks like the cabinet maker used two rear drawer brackets, which I don't think is necessary. I think you should consider our 32-089. Check it out and see what you think.
A quick learner from texas says:
I don't think that would work. The mounting strip for the bracket sits several inches higher than the level mark for the rail. The screws would go through the thin back wall of the cabinet itself.
Profile picture of Dave
Dave from SWISCO responded:
You could consider some of our hanging brackets like our 32-094, 32-025, and 32-116. If these cannot match, though, then you will have to find a way to retro fit a bracket like the 32-089.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)