SWISCO - The Replacement Hardware Authority

stationary screeen pin

A quick learner from massachusetts says:
this is on the top of a screen it only goes through the frame to the spline track not all the way through
User submitted photo of their screen pin.
Profile picture of Paul
Paul from SWISCO responded:
When we used to make screens that needed a stationary pin, we would used our 70-008 pull pin. Check it out and see what you think.
A quick learner from Massachusetts says:
I have some of the 70-008 pins but they are to thick to fit in the holes in the windows I was wondering if you had anything with a 1/8 inch shank? I was thinking of the 70-195 but i was not sure if they would work do you have a picture of them in a screen
Profile picture of Paul
Paul from SWISCO responded:
Ah, I see. For 1/8", I think the 70-195 is a good choice.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)