With the door in the closed position place the fold of the template on the inside of the door against
the wood stop or metal z-bar (place at a height that it will miss the main door knob). Spot the holes
using the template.
Drill (3) 5/16" holes straight through the door.
Place the handle assembly into the holes of the door. Lining up the plunger with the hole in the bottom
of the latch, place the inside assembly in the door and mount it with the (2) included screws.
Check the handle latch to be sure that it operates freely.
Line up and place the strike with the dead bolt and latch. The striker should be flush with the z-bar.
If the strike is too low, use shims to build up to the correct height. Mount the striker with the (2)