SWISCO - The Replacement Hardware Authority

How to replace the handle on a Pella Rolscreen sliding door

These instructions apply to:
Architect Series® 12/2004 - Current
Designer Series® 3/2005 - Current
1) Removing The Screen Handles
1A) Remove the Pella emblem from the handle using a slotted screwdriver. Using a phillips screwdriver, remove the screw found underneath the Pella emblem.

1B) Remove the interior handle. Then remove the thumb button.

1C) Remove the lock catch. Then remove the exterior handle.

How to remove the handle on a Pella Rolscreen sliding door
2) Installing The Screen Handle
2A) Install the replacement handle in the reverse order. Install the exterior handle first.

2B) Now install the lock catch. Make sure that the hole in the lock catch fits over the screw hole in the exterior handle. Next, install the thumb button making sure the smaller hole in the thumb button part aligns with the tab in the back side of the exterior handle.

2C) Insert the interior handle. Insert and tighten the screw while holding the interior and exterior handles in place.

2D) Install the Pella emblem.
How to install the handle on a Pella Rolscreen sliding door
Discussions that mention this guide
Discussion # Of Replies Last Post Date
no discussions have been started yet
Have a question about this guide?
Use this form to ask questions or to share your experiences regarding this guide. Every discussion will be reviewed and answered by our experts.
(your email address will be kept private and is only used to inform you when a response has been made)