Channel Balance Accessories Replacement Guide

Step 1

Carefully drill through the existing rivet using the SWISCO 75-205 3/32” drill bit. Drill through the crimped side of the rivet. If you have trouble pulling out the rivet use snips to cut the rivet and remove the rivet completely.

Step 2

Remove the old channel balance accessory and slide in the new one. Align the holes so that you can insert the new rivet.

Step 3

Place the balance on a solid surface (like a metal plate) with the flat end of the rivet facing down. Place the tip of the SWISCO 75-075 rivet punch tool into the top open end of the rivet.

Step 4

Firmly tap the top end of the rivet punch tool with a hammer to crimp the rivet.

Step 5

After the rivet is crimped, gently tap the crimped end of the rivet to flatten.

Related Item(s)

Rivet, 3/32" x 39/64"

62-005

Rivet, 3/32" x 7/16"

62-010

Rivet Installation Tool

75-075

3/32" Drill Bit

75-502