ShopAbout UsPart IdentifierShop SWISCO.comAbout UsPart IdentifierShop SWISCO.com How to Install the 10-402 Out-Swing Partition Latch Repair Kit

Installation Instructions

Installing the 10-402 Out-Swing Latch Kit



STEP ONE:

Fit the ‘Cover Plate’ to the edge of the door and center over the existing ‘concealed latch’ hole.

STEP TWO:
Press firmly to the door edge.

STEP THREE:
Using a 1/4″ drill bit, drill (4) holes through the door, using the holes in the cover plate as a template.

STEP FOUR:
Secure the ‘cover plate’ to the door with the included (2) 5/8″ barrel nuts and (2) #10-24 x 15/16″ shoulder screws.

STEP FIVE:
Mount the latch to the door with the included (2) 1/2″ un-slotted barrel nuts and (2) #8-32 x 1 1/8″ machine screws. When installing the outside pull, it will require the use of the included (2) #8-32 x 1 3/8″ machine screws and no barrel nuts.

STEP SIX:
Locate the strike/keeper and mark the installation holes.

STEP SEVEN:
Drill through the pilaster using a 1/4″ drill bit. Secure the strike and keeper using the included (2) 5/8″ barrel nuts and (2) #10-24 x 1 3/16″ shoulder screws.

 

Leave a comment


The reCAPTCHA verification period has expired. Please reload the page.