Drawer Slide Replacement

Home Owner from Billerica, MA

Nov 12, 2013 9:13 pm

Part Needed:

Plastic Drawer Slide

Mfg. ID Raised Lettered -- "Hardware Designer Inc. #452

(1) Oval Shaped adjustable screw slot - top - centered.
(2) Additional screw holes -- Each 3/8ths in from each side.

"Mouth" = 1-3/4in. wide.

Richard

4 Replies

Tom from SWISCO

Nov 13, 2013 11:12 am

Thanks for posting, Richard. I would start by looking at our 32-088. Check it out and let me know if you could use this as a replacement.

Home Owner from California

Jan 2, 2014 11:10 pm

I need to replace some Rear Drawer Guides for my kitchen cabinets.
Here's what is written on my part: "Hardware Designers, Inc. #452 U.S.A."
It appears to have the following dimensions:
Total Height: 1 9/16"
Total Width: 2 1/2"
Gap from fin to fin (between mouth): 7/8"
Gap internal mouth width (below fins): 1 1/4" to ~1 5/16"

Can someone suggest a replacement part?
Pic is attached.
Thanks!

Tom from SWISCO

Jan 3, 2014 11:52 am

Thanks for posting! I've placed you into an existing thread concerning this same guide. Check out the information above and see what you think.