Slider door handle on two sides

A quick learner from Naples FL says:
I would like to mount a pull handle on the outside as well as inside of my slider. I don't mind replacing all the hardware and don't necessarily need to lock as I'm on the second floor. Do you have any suggestions?

Door I thickness is 1 5/16 inch
Screw hole C/C is 6 5/8 inch
Open hole measures 7 1/8? x 5/8?
Lock is on the bottom - center

Bill
User submitted photos of patio door hardware.
Profile picture of Dave Sr.
Dave Sr. from SWISCO responded:
Hey, Bill. Your locking handle appears to match our 82-002, or 82-002W in white. I'm not sure if these will work on your 1-5/16" thick doors, though. Our handles are meant to be used with 1" thick doors. However if you locking handle is OK I suggest installing a pull handle like our 88-009 above or below you existing handle. Just check to see if you have the clearance between the glass and screen door. Also check to see if you need to adjust or replace your bottom door rollers to make the door slide easier.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)