Viewing all customer Discussions for:

Door & Window

Need to know what part number/size I need for pictured window. 4 pivots and 4 of the sliders

Hi I will need 8 rollers shown in the pictures. The sliding doors were made by a company called Guardian out of South Carolina back in the early 80's

I need these clips (right and left) that screw into side of window sash that engage with coil balance-- the coil balances that I need are stamped with a number 2440 that are 25" edge of metal to edge of metal, can yopu help identify these parts so I can order?

International Window Lanai 5000 vinyl out swing French door with side windows. Broken handle on the right panel.

Can you identify this part and let me know if you sell it. Roughly 1.5" W x 1.5" H and is goes on the side of a PVC sash. Dont know the brand.

These wheels cant be adjusted anymore and need to be replaced. The number I could find on theseis 6572. The marking on the glas is the following: pPG Herculite K, ANSI-Z-97 1-1972 3/16" U Temp safety Glass SGCC - 02 11372

Unknown

the keeper slides into the window, holes are 1" apart, from center of hole to the top is 1.5" it is also 1.5" from edge to edge. The lock holes are about 2 and 1/8 from center to center and 1/2" back to center of hole from keeper

Hi. Our window won't stay up. Total length 30 inches. It's for non tilt window. Please see attached pictures. Thank you

I am looking to replace this part which is from an older patio door. The wheel is 1-1/2" diameter, 3/8" wide and the hole in the center is also 3/8". I could just do the wheel if not the whole part, but i can't seem to find one that has a steel bearing and nylon/plastic outer wheel part. Thank you ... (cont.)

Use to stabilize the window in the side rail.

Two large exterior screen doors with two rollers per door. Have been to numerous local hardware stores without any luck. Pic 570 shows the part installed (screen door has been removed and is on it's side); Pic 569 shows screen door after removal of the part. Final three pics are the part I am see ... (cont.)

Hello, I always seem to miss your open hours for a live chat as I am on the West Coast, so thought I would write a message instead. I have two separate windows in an older house (ca. 100 year old craftsman style) in Seattle that are having problems with failing window balances, but I am pretty ... (cont.)

Did not measure so I am unsure of the dimensions.

Looking for screen clips/retainers that are used to hold the screens in place.

Good Morning, I hope this message find you well. I'm looking for this internal lock. at this moment those are the photos I have and I would like to know if with them you would be able to identify the lock.

Hello, I am looking for a replacement for the pics above. My latch has broken, and I cannot lock the door. Can you help me?

Looking to replace the latches that allow for tilting in. Not sure how to take them out. Lock picture is the only thing with a name on it. Thank you.

I'm trying to fix a window that has been broken for a few years now. Upon inspection, one of the balances has a messed pulley so they'll both need to be replaced. It has 28 6 EW CMC 10 on it and the metal part of it is 29 1/8 inches. Also the metal bracket in the sill is bent and loose. Thanks for ... (cont.)

I have this length is 29", 5/8" wide channel, with stamp 28B.