Viewing all customer Discussions for:

Door & Window

Need replacement for cole Sewell storm door handle gold or antique brass. Part#01079794531 9 or maybe that's the dirt #.

The bar is 2 - 13/16 " long the outside screw hole is 1 - 7/16" in and the second hole is 2 - 7/16". The measurement for the holes are to the center. There is the number 5 in a circle to the outside of the outer most screw hole. Both screw hole appear to be threaded and the screws do not appear to ... (cont.)

Hi, I am in need of help finding a replacement for my windows the coil system broke and the window is very heavy to lift. Can you please advise which part I need to purchase to replace. thank you, kate

Hello, I have a vinyl window of unknown origin with a broken coil housing spring. the picture of the removed part is the left side, the installed one is the right. The top spring is kinked and broken so needs to be replaced. One coil is 4 lbs the other is 5. Question 1 - Is there a coil with a l ... (cont.)

The overall length is 1.924", width .3050" ,screw hole center is 1.6285" only one screw holds it to the window frame. The low height is 3025" the taller section is 375". The rollers were missing. House was built in 1985

Channel length 15" x 9/16"; stamped 14 3. Unknown window manufacturer. I would like to order 2 balances.

The door keeper (believe that's what is in the photo) has broken off on the frame of my Windoor 8100 sliding door so there is nothing for the latching hardware (on the sliding door) to catch or lock onto. Curious if you sell a replacement for this part. Thanks! John

there are no numbers, manufacturer logos, or letters on the handle. I recently ordered 2 from Swisco that appeared to be the same, but are much shorter. The color is a perfect match. our windows were installed before we purchased our house, and we don't have any information on them. there are no ... (cont.)

Photo is of working right corner. Approx - 1" dimensions of latch needed for left corner are: 2.5" main part: then spring 1"; and then push/pull tab .025".

Looking for replacement operator for fleetwood casement window

Extended Travel Channel Balance for single hung window metal length 27" , width of metal =1/2" Stamped on metal is 26 4. In smaller letters stamped across metal is BSI House was built 2006 qty needed = 2 Extended travel channel balance for single hung window Metal channel length 21", also stam ... (cont.)

Need spiral balance for Acroline window Color Blue Diameter 5/8 Tube length 30 inches

Hello, We are looking for balance replacements and trying to recognize the Jamb Liner type or to replace it. Do you know what I can use if we have to replace this jamb liner?? Thanks, Robert

My windows face the sun and are brittle, need maybe 15 to replace the bad ones

what might be a good alternative model to this for replacement?

I was looking for this arm, I belive a Truth Hardware

I'm looking for replacement hardware. Might be: Pella Roto Operator, 1967 to 1993, CC / WC-Right Hand Pella Roto Operator, 1967 to 1993, CC / WC-Left Hand

Need this part

So I am trying to replace both a coil balance and a pivot shoe on a set of windows that I have at home. I'm pretty sure I have found the parts but am confused on the random flathead tip screw that is located above the coil balance. It can twist both counterclockwise to extend into the channel and ... (cont.)

Can you please assist in identifying the correct window balances for my window? It is 29" long and 1/2" wide. Please let me know if you need any additional info. Thank you.