Jasmine from SWISCO responded:
January 24, 2024
Thanks for writing in! I believe you can use our Series 140 Quick Tilt Balance assembly to replace your Anlin coil balances. Since yours is stamped with a 6L, you'll need the S140-6. You'll be able to select the orientation needed for your replacement. Take a look over the dimensions below to confirm that this is the right replacement. Alternate image for S140-7
There are two compatible pivot bars that could be a possible replacement for your existing pivot bar. They are the 26-398 and 26-405 round end pivot bars. To confirm which of these is the right replacement, carefully look over the dimensions and compare them. See what you think! Detail of 26-398
Alternate image for 26-405
|
Jasmine from SWISCO responded:
January 24, 2024
It does not appear that we carry an exact match for your pivot bar. The suggested pivot bars are the ones compatible with the Series 140 assembly, so the difference in design should not be an issue. The length of the pivot bar is not of as much importance as the placement of the installation hole(s). Unfortunately, that isn't something I'll be able to confirm from the photos. So long as one of them matches up to the hole on your existing bars, the replacement should work just fine. It may help to look for a sash that has an undamaged pivot bar. You may be able to get a better idea of the measurements that way. |