July 3, 2023
The sliding piece is a little tight when I try to install. Can you advise the best way to go about installation.
Thank you.
July 3, 2023
Solved--I heated the plastic pieces in hot water and they snapped in place.
July 5, 2023
I heated the water to well below boiling point--just above where I couldn't really touch it. I inserted the pieces for about 15 to 30 seconds and that was sufficient. By the way, one of the latches was pre-installed in the assembly backwards! So I had to insert the assembly in the water and then pry out the latch and turn it around.