door handle

Home Owner from Cincinnati OH
product code 40-040
I have a an old door with this handle on it, but the spring has broken and your product mentioned above looks like the same thing. What I can't tell on your site is the dimensions. I have some pics included. sorry it is hard to see the tape measure on the vertical shot but the measurement of the hole is about 1" wide by about 3/4" tall.

The door is 1" thick. the distance of the hole to the edge of the door is about 7/8".

Please advise if your handle meets these specifications.

Regards,
Lee
User submitted photos of a door handle opening.
2 Replies
Tom
Tom from SWISCO
SWISCO
Expert
Thanks for posting! Yes, it looks like the 40-040 could fit in that hole. However, keep in mind that you may have to drill new screw holes.

I also recommend that you take a look at the installation instructions for the 40-040 and double check to make sure you will be able to install it with your current set up.
Additional information for 40-040
Additional information for 40-040
Reply to Thread
Current Photos: