I'm looking for roller assemblies to replace the one in the picture. They're very hard to find! This one looks like it might do. The height isn't quite the same, but depending how low the wheel can go, it might be ok.
The dimensions i see including the flange at the end are good. However, you don't specify the outside width of the assembly *without* the flange. Mine is .71". That's the widest point without the flange (there's a bump at the other end, that's where i measured the width).
So would this assembly do?
And how far down can the wheel drop?, measured from the bottom of the wheel, to the top of the assembly?
Finally, do you have any other assemblies that might fit?
Thank you!
