Viewing all customer Discussions for:

81-303 Roller Replacement Axle, 1/4" x 1"

Hi there, I am helping my friend fix her sliding glass door The center door is the only pieces of glass (there are 3 panels tot) that moves and one of the rollers popped out. Ideally I would like to replace both rollers, use the existing frame and glass, but I cannot figure out how to get the s ... (cont.)

I looking for replacement rollers and possibly the housing as well for the attached images. The house was built in the 57 and I think the sliding glass door / sunroom was added early to mid 60's. The frame is entirely aluminum . There are 2 rollers on each door panel . Each door is 48" x 81" approx. ... (cont.)

But I anticipate rebuilding two axles and wheels. Please, not that the axle is 3/4" long and so is the frame of the patio door it sits in. Can't find this size on your page. Help.

Markings: Del Mar Eng Long Beach CA Pat Pending it looks like the D7000 series style from PE Del Mar catalog p 13, but I am not sure which one it is the wheel diameter is 1.5" on PE Del Mar catalog B=D=1.48" A =.625 I would like stainless steel as the door is near the ocean

We purchased a house with two sliding glass doors that need new rollers. We don't see any brand name markings on the doors, but the wheel is imprinted on the side with " KILIAN " TORONTO, CAN. SYRACUSE, N.Y. The wheel assembly is held in place with a 15/16 inch spring pin, and the wheel is hel ... (cont.)

I’m looking to purchase nylon rollers for a patio sliding glass door (*) and will need pins to go with it. All I see is “kits” of pins on the website, do you sell the specific pin that is required for the wheel separately? I’m am not going to need nor have the use for the other pins and thus would b ... (cont.)

Can we replace the wheel 81-228 by 81-241 and what should be the axle associated with it thanks

The wheel looks identical to the one used by the 23-043 assembly. I'm fairly confident I can drill out or grind of the rivet holding the existing damaged wheel. Do you sell a male/female shoulder bolt or a replacement rivet for the 81-228 wheel? Thanks, Don

Are the axels either center dirilled to facilitate tapping or tapped for screws/bolts? If drilled or tapped, please provide parameters.