replace handle

A contractor from orem, utah says:
October 3, 2011
I need to find a replacement handle for this door. The top & bottom holes are 4" apart on center.
User submitted photo of their sliding door.
Profile picture of Dave Sr.
Dave Sr. from SWISCO responded:
October 4, 2011
Take a look at our 82-035 - this handle may be a good fit for you. The distance between the installation holes of the 82-035 is 3-15/16" which is very close to your measurement of 4" - see if that would be a problem or not.
A contractor from orem, ut says:
October 5, 2011
It is unclear from the pics how the lever for the latch is installed (only 2 wholes on the mounting plate).
Profile picture of Dave Sr.
Dave Sr. from SWISCO responded:
October 7, 2011
You have two holes to install the locking handle. The thumb turn rests in behind the handle plate in a little indentation.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)