How to use the 10-401 in-swing partition latch repair kit
Installation Instructions
Fit 'Cover Plate' to edge of door and center over existing 'concealed latch' hole.
Press firmly to door edge.
Using a 1/4" drill bit, drill (4) holes through the door, using holes in cover plate as
a template.
Secure 'cover plate' to door with the included (2) 5/8" barrel nuts and (2) #10-24 x
15/16" shoulder screws.
Mount latch to door with the included (2) 1/2" un-slotted barrel nuts and (2) #8-32 x 1
1/8" machine screws. When installing the outside pull, it will require the use of the included (2) #8-32 x 1
3/8" machine screws and no barrel nuts.
Locate strike/keeper and mark the installation holes. If necessary, use the included
spacer plate under the keeper as needed to adjust the latch bolt.
Drill through pilaster using a 1/4" drill bit. Secure strike and keeper using
the included (2) 5/8" barrel nuts and (2) #10-24 x 1 3/16" shoulder screws.