Replacement sliding glass door rollers

Question

Rollers shown are from neighbor's door, houses were built same time, same builder. My door is very hard to slide, especially as it gets colder. House was built in 2005. Rollers are stamped Delta 2188. Measurements are close to your 81-156, but enough different to make me check with you before ordering.

And what is the advantage of the 81-156SS over the 81-156?

Thanks in advance!!

Casey · Accepted Answer

Hello,

I agree that the 81-156 would be our best replacement option for the roller assembly shown in your photos. The dimensions look close to ours but the hole spacing is a bit off. With that being said, I would recommend double-checking your measurements to make sure that you are measuring between the center of your installation holes.

The 81-156SS is the stainless steel version of the 82-256, meaning that it would hold up better in areas close to salt water and large amounts of moisture. If you decide to give one of these a try and run into any problems, our return policy can be found here. Thank you.

Alternate image for 81-156