1955 era closet door rollers
Handy Person from hayward california
Sep 10, 2019 9:24 pm
looking to replace about 5 bad ones
2 user uploaded images
6 Replies
Casey from SWISCO
Sep 11, 2019 11:14 am
Thank you for your post! I'm having hard time identifying this part. Is this hardware fully assembled? Can I have a picture of where this closet door roller is located?
Handy Person from hayward california
Sep 12, 2019 8:06 pm
The picture of the roller assembly pushes into the end of the closet door. I have attached pictures that show a roller pushed into the bottom of the closet door. Another picture shows the end open because I removed that roller. The last picture shows the entire door assy. The end where the roller pushed into is 7/8 x 7/8 and about 3/4 deep. I hope this helps
3 user uploaded images
Tom from SWISCO
Sep 13, 2019 2:24 pm
Unfortunately your doors are too old to come across this type of roller assembly.
We might be able to supply you a new wheel and axle to replace your wheel in the housing.
We will need the diameter and width of the wheel and the axle.
Handy Person from hayward california
Sep 13, 2019 10:35 pm
the diameter of the wheel is 12/16 or 11/16.
the width of the wheel is 5/16
the diameter of the axle (riveted pin) is 2/16
The wheel is also plastic. The diameter of the wheel is greater at the ends then the center. You can see that in the pics I sent in.
Thank you.
the width of the wheel is 5/16
the diameter of the axle (riveted pin) is 2/16
The wheel is also plastic. The diameter of the wheel is greater at the ends then the center. You can see that in the pics I sent in.
Thank you.
Paul from SWISCO
Sep 18, 2019 7:25 am
Thank you for your patience as we looked into this matter. I regret to inform you that after extensive research, we have been unable to find a roller that can replace yours. I apologize for the inconvenience.
