Close but not quite
Home Owner from Bowie, MD
Jun 1, 2011 6:31 pm
I need to replace the right rear mounting bracket for my cabinet drawer. The 32-089 is SO close to chat I need. The only differences are that where the portion of the picture above measuring at 3 and 11/16 inches would need to be 2 and 3/16 inches instead and there is a slot at the bottom of the right bracket AND the left bracket (instead of just on the right bracket as shown above) although I don't think that it matters much due to the type of track that was used. Do you have a mount like that??
4 Replies
Tom from SWISCO
Jun 2, 2011 8:26 am
I looked but we do not have a drawer socket that is similar to the 32-089 with your measurements. If all the other measurements are the same and your drawer track fits into these sockets, would the longer length be a problem?
Home Owner from Bowie, MD
Jun 2, 2011 3:43 pm
I'm hoping it wouldn't. I am worried because of the slight bend in the track itself. With the one that is being used right now (before it broke) it allowed for the curve by being long enough to hold the track up to the bend.
Does this part allow for a bend in the track?
Does this part allow for a bend in the track?
Dave Sr. from SWISCO
Jun 3, 2011 9:38 am
I'm not too sure about the bend. You could possibly replace the complete track if you feel as if the 32-089 will not work in your situation.
Related Products