Commercial bubble seal corner

Question

Will your commercial vinyl bubble seal make a 90 degree corner, possibly if heated. Old seal which was cut at corners, shrunk leaving gaps. Need to install by bending flange into groove, rather than sliding in, will that work? Also looking for a rainproof seal that can fill a 1/2" gap, yet be crushed down in spots to near 0", for a car ramp/door where the gap varies. Thanks for your help.

Dave Sr. · Accepted Answer

That 90 degree corner you mention is something that is normally done at the factory at the time of manufacturing. I would suggest using a type of silicone caulk to seal the corners. You'll find that to be a much easier project. As for the rainproof seal, take a look at the 58-180 self adhesive foam weather stripping. I can't be sure, but this might help sealing up what you need. See what you think.