Contractors Wardrobe Mirrored Bifold Doors - 1999

Question

I have bifold mirrored doors manufactured in 1999 by Contractors Wardrobe (CW). The pivot bracket on one side jumps in the track, and the door will not open or close properly. The bottom track appears to have spread. The hardware appears very similar to Stanley hardware - perhaps manufactured by them, except that some of it is labeled CW. The existing track is 72" long. The track is 1" wide and about 7/8" deep. The pivot itself looks much the same as a Stanley pivot. Unfortunately, I am not strong enough to lift the doors out. The tracks appear to be the problem, although the pivot brackets are worn.
Will the 21-455 track and its accessories work with my doors? Would I need new pivots and the plastic blocks?

Casey · Accepted Answer

Hello,

Your corner connector resembles the 23-409. We can't be sure of the pins your door uses without seeing the originals uninstalled but the 23-116 pivot is commonly used for the bottom and the 23-115 and 21-174 roll guide would install at the top of the door. If these match your original hardware, the 21-455 would be the recommended replacement for your original tracks. Thanks for posting!