Your Product Code 83-034 shows the z-shaped "die-cast keeper" in the lower right hand corner of the Catalog Cut-Sheet.
How/where can I get only said "keeper"(as that is all I need ?
Thank you.
Dave Moes
Die-cast Keeper for Sliding Screen Door

Home Owner from Avon Lake, Ohio
Apr 24, 2012 11:02 am
6 Replies

Dave Sr. from SWISCO
Apr 24, 2012 2:54 pm


Thanks for posting! Do you have the 83-034 sliding screen door handle? If not, it's possible you may have one of our other metal screen door keepers. Take a look through our Patio Sliding Screen Door Keepers catalogue and see if you can find anything that more closely matches your keeper.
If not, or if you aren't sure, let me know, and please provide dimensions for your existing keeper for me to look at! If at all possible, a few pictures of it couldn't hurt, either.
If not, or if you aren't sure, let me know, and please provide dimensions for your existing keeper for me to look at! If at all possible, a few pictures of it couldn't hurt, either.

Home Owner from Minnesota
Apr 30, 2012 11:47 pm
I too need just the casted keeper. I'd like to buy 4 (I have 2 broken ones). Do you make a stronger one... maybe a machined version or formed sheet metal?


Dave Sr. from SWISCO
May 2, 2012 8:05 am


Thank you for your patience in this matter. Unfortunately, the keeper for the 83-034 sliding screen door latch and pull is not sold separately. I apologize for the inconvenience.

Home Owner from Minnesota
May 2, 2012 9:29 am
Thanks Dave. One more question... could you provide me the following dimension? (see picture).
Thanks again for your help.
Thanks again for your help.


Dave Sr. from SWISCO
May 2, 2012 9:46 am


The offset of the keeper, as highlighted by your image, is approximately 5/8".
Related Products