Does the 10-556 come with locking washers?
A quick learner from Tennessee says:
April 25, 2011
Does this knob assembly come with locking washers to hold the two pieces in place?
![]() |
Mike from SWISCO responded:
April 26, 2011
|
A quick learner from Trimble, TN says:
April 27, 2011
I am going to purchase the 10-556 assembly so where can I get the washers?????
![]() |
Mike from SWISCO responded:
April 28, 2011
As far as I'm aware, you should not need locking washers to hold the Swisco 10-556 Knob Assembly in place. However, I will look further into this situation and see if I can find more information regarding locking washers.
|
A quick learner from Trimble, TN says:
May 3, 2011
What holds the two pieces together?
![]() |
Mike from SWISCO responded:
May 4, 2011
The female end of this knob set has a round spring clip that is "staked" into the center of the casting. This is done as a secondary manufacturing process. There is a hole in this spring clip that locks onto the male stem. Unfortunately, once the staking points are broken you cannot replace the spring clip. At this point, the knob would have to be replaced.
|
A quick learner from Trimble, TN says:
May 4, 2011
I assume that the knob assembly will be shipped in two separate pieces.
![]() |
Mike from SWISCO responded:
May 5, 2011
|
![]() |
Mike from SWISCO responded:
January 19, 2012
For reference, here's a tutorial video on the installation of the Swisco 10-556 Lavatory Knob Assembly:
|