Fastener for Drawer Roller

Question

You were referred by Davis Kitchens in Tuscon, AZ. They did the original installation which was an on-site cabinet conversion to roller drawers. The part I need is the plastic bracket which attaches the roller guide to the back of the cabinet. The roller guide slides into the attached bracket. There are no markings on the bracket. If you need additional information, just ask.

Tom · Accepted Answer

Start by looking at our 32-119. This looks like it matches your socket stylistically, but I'm not sure about its size. The most important measurement is the opening that accepts the track. Look over our measurements and see if they're the same as yours!