Glass Sliding Handle System Replacement

Home Owner from USA

Oct 17, 2019 8:04 am

Hi,

I am trying to look for the correct replacement door handle system for my glass sliding door at my condo unit. I would appreciate it if you can assist with identifying the correct part before I place an order. I think it belongs to Milgard-C1275 or C.R. Laurence model but need to confirm if the dimension/handle ht between the two screw holes on the system (4-15/16") matched with the measurement of my existing door slot shown on the sliding door (refer to attachment). I look forward to hearing from you soon.

Thank you,
Anthony

4 Replies

Bob from SWISCO

Oct 18, 2019 12:40 pm

Hi Anthony. This looks like our 82-080, which has a hole spacing of 4-15/16". Look it over and see if you agree.

Home Owner from USA

Oct 18, 2019 2:39 pm

Hi Bob,

Comparing the hole spacing of 4-15/16" with the picture taken with measurement on the handle it appeared the height is shorter than 4-15/16". Is 4-15/16" an industry standard or is there other model with shorter height (e.g. 4.5")?

Thanks.

Bob from SWISCO

Oct 22, 2019 12:31 pm

Hi Anthony. It's a bit hard to tell from your photos, but the illustration at the bottom clearly shows the hole spacing of 4-15/16". The overall height of these handle sets has changed over the years, but the 4-15/16" is the standard for handle sets of this configuration. If you're uncertain, show us a clearer picture of your existing set's hole spacing. Many thanks.