I am in need two sets of non-locking PGT sliding glass door pull handles
To whom it may concern
These doorhandles will need to be black
I have two similar locking mechanisms one is a 2320 Dash 10 S hook up alignment keeper. The other is a 32439 hook up alignment keeper both of them are secured to a trim plate. The latch face trim plate measures five and three-quarter inches long and 1 inch wide around a half an inch deep
The black pull handle set measures 8 1/2 inches long by 1 inch wide
The door keeper is 4 inches long and three-quarter inch deep
Below the door keeper is a single rubber bumper which measures approximately three-quarter inch diameter and a quarter inch thick I would need 2x of these
The distance between the two bolts which secure the handles through the sliding glass door are 4" inches apart
Please let me know what you recommend best regards Darius
